$2,835.99EACH
- Description
- Specifications
- Documents
Amprobe DGC-1000A Clamp Ground Resistance Tester
Features and Specifications- Accurate ground resistance measurement from 0.025 to 1500 Ohms
- True-rms current measurement including leakage current
- Accurate readings regardless of power quality in less than 10 seconds
- Air-tight jaw to enclose electrode or ground rod
- Continuity beep if the resistance is lower than 40.00 Ohms
- Simple and easy to use, no test leads or auxiliary electrodes necessary
- Data logging capability – 116 records
- Individual data point recording
- Display type 4 digits 9999 counts LCD
- Freeze value on screen
- User selectable high low ohm audible alarms
- Safety rating Category III 300 V and Category II 600 V
- Auto power off (can be disabled)
- Low battery indicator
- Large LCD display
User-Friendly And Accurate Tester
The DGC-1000A is a true RMS (root mean square) meter providing accurate readings when measuring linear or non-linear loads where the current or voltage has a sinusoidal or nonsinusoidal waveform. The clamp-on head enables the user to measure resistance on a ground rod in a multiground system without the use of auxiliary ground rods and without disconnecting the other grounds. The on-board memory and data logging features improve efficiency.
It's designed for use by electricians and electrical contractors for measuring ground resistance, current, and continuity in multi-grounded electrical systems.
What's in the Box- DGC-1000A
- Resistance calibration plate
- 9 V battery (installed)
- Carrying case
Brand:Â Amprobe
Conductor Size:Â 2.3cm
Display Digits:Â 4
Display Type:Â LCD
Ground Resistance:Â 0.025 to 1,500 ohms
Indicator:Â Audible
Jaw Opening Size:Â 2.7 cm
Safety Rating:Â CAT2, CAT3
True RMS:Â Yes
$2,835.99EACH